TABLE OF CONTENTS
SD Card Replacement:
To access the SD card on your DAKBoard Mirror Display, follow the steps below:
- Lay your Mirror Display mirror side down. On the back, you will see a door that you can open. The opened door will have the Raspberry Pi Computer as seen below:
NOTE: The Grounding Cable that is loose in the device is not used by us. If you see this know that it is not expected to be attached to anything.
- The SD Card can be located opposite the USB and Ethernet ports on the bottom of the computer. See below:
- This can be pulled out of the CPU. You can do this with your fingers or carefully with a pair of needle nose pliers:
- Once you have upgraded or chosen to replace the SD card with the latest OS, you can put it back into the Display and push it in with your finger:
- Make sure it is fully inserted as seen below:
- Once it is in place you can close up the door and power on your Device. Follow the onscreen instructions to connect it back to your account.
Helpful Articles:
Having trouble? See if these articles help:
Wall Display 27 and V2 Plus (Mid-2022 and Newer) SD Card Replacement
V2 and V2 Plus SD Card Replacement
DAKboard Touch 22 SD Card Replacement
DAKboard Mirror Display SD Card Replacement
Dell 27" Wall Display SD Card replacement
Raspberry Pi - Download and Install the DAKboard OS
Orange Pi - Download and Install DAKboard OS